Helical / Compression spring manufacturing process

Raw Materials

Steel alloys are the most commonly used spring materials. The most popular alloys include high-carbon

Design

Various mathematical equations have been developed to describe the properties of springs, based on such factors as wire composition and size, spring coil diameter, the number of coils, and the amount of expected external force. These equations have been incorporated into computer software to simplify the design process.

The Manufacturing Process

1 Cold winding.

Wire up to 0.75 in (18 mm) in diameter can be coiled at room temperature using one of two basic techniques. winding the wire around a shaft called an arbor or mandrel

A guiding mechanism, such as the lead screw on a lathe, must be used to align the wire into the desired pitch (distance between successive coils) as it wraps around the mandrel.

2 Hot winding.

Thicker wire or bar stock can be coiled into springs if the metal is heated to make it flexible. Standard industrial coiling machines can handle steel bar up to 3 in (75 mm) in diameter, and custom springs have reportedly been made from bars as much as 6 in (150 mm) thick. The steel is coiled around a mandrel while red hot. Then it is immediately removed from the coiling machine and plunged into oil to cool it quickly and harden it. At this stage, the steel is too brittle to function as a spring, and it must subsequently be tempered

3 Heat treating.

Whether the steel has been coiled hot or cold, the process has created stress within the material. To relieve this stress and allow the steel to maintain its characteristic resilience, the spring must be tempered by heat treating it. The spring is heated in an oven, held at the appropriate temperature for a predetermined time, and then allowed to cool slowly. For example, a spring made of music wire is heated to 500°F (260°C) for one hour.

4 Grinding.

If the design calls for flat ends on the spring, the ends are ground at this stage of the manufacturing process. The spring is mounted in a jig to ensure the correct orientation during grinding, and it is held against a rotating abrasive wheel until the desired degree of flatness is obtained. When highly automated equipment is used, the spring is held in a sleeve while both ends are ground simultaneously, first by coarse wheels and then by finer wheels. An appropriate fluid (water or an oil-based substance) may be used to cool the spring, lubricate the grinding wheel, and carry away particles during the grinding.

5 Shot peening.

This process strengthens the steel to resist metal fatigue and cracking during its lifetime of repeated flexings. The entire surface of the spring is exposed to a barrage of tiny steel balls that hammer it smooth and compress the steel that lies just below the surface.

6 Setting.

To permanently fix the desired length and pitch of the spring, it is fully compressed so that all the coils touch each other. Some manufacturers repeat this process several times.

7 Coating.

To prevent corrosion, the entire surface of the spring is protected by painting it, dipping it in liquid rubber, or plating it with another metal such as zinc or chromium. One process, called mechanical plating, involves tumbling the spring in a container with metallic powder, water, accelerant chemicals, and tiny glass beads that pound the metallic powder onto the spring surface.

Alternatively, in electroplating, the spring is immersed in an electrically conductive liquid that will corrode the plating metal but not the spring. A negative electrical charge is applied to the spring. Also immersed in the liquid is a supply of the plating metal, and it is given a positive electrical charge. As the plating metal dissolves in the liquid, it releases positively charged molecules that are attracted to the negatively charged spring, where they bond chemically. Electroplating makes carbon steel springs brittle, so shortly after plating (less than four hours) they must be baked at 325-375°F (160-190°C) for four hours to counteract the embrittlement.

8 Packaging.

Desired quantities of springs may simply be bulk packaged in boxes or plastic bags. However, other forms of packaging have been developed to minimize damage or tangling of springs. For example, they may be individually bagged, strung onto wires or rods, enclosed in tubes, or affixed to sticky paper.